 |
Capable of withstanding repeated cycles of autoclaving, radiation, EtO and cold sterilants, EP42HT-2Med is a room temperature curable, two part epoxy that complies with USP Class VI testing. It has excellent electrical insulation properties and can be cast in sections exceeding 2-3 inches thick. EP42HT-2Med is widely used in the health industry for manufacturing endoscopes, surgical instruments, catheters and many other medical devices.
|
|
USP Class VI Epoxy for Medical Devices |
EP21LVMed is a two component, low viscosity epoxy resin system for high performance bonding, sealing, coating, encapsulating and casting. It produces high strength, durable bonds which hold up well to thermal cycling and resist many chemicals. Serviceable over the wide temperature range of -65°F to +250°F, EP21LVMed has a convenient one to one mix ratio.
For more information, request a technical data sheet on EP21LVMed
|
|
Non-Toxic Cyanoacrylate for Bonding Applications |
Low viscosity MB250NT is a single component ethyl cyanoacrylate that cures exceptionally fast at room temperature. This high strength, non-toxic system meets ISO 10993-5 standard for cytotoxicity. It is often used in high speed production of disposable medical devices and also has first rate resistance to EtO and gamma sterilization processes. As a non-toxic system, MB250NT is environmentally friendly.
For more information, request a technical data sheet on MB250NT
|
|
Silicone Compound for High Performance Medical Applications
|
MasterSil 151Med is an optically clear, flexible, tough, high performance potting and encapsulation compound by Master Bond. It exhibits superior electrical insulation properties and very low shrinkage upon cure. MasterSil 151Med is resistant to vibration/shock and has a service operating temperature range of -65°F to +400°F. It meets USP Class VI requirements for medical applications.
For more information, request a technical data sheet on MasterSil 151Med
|
| Medical Grade, Electrically Conductive Adhesive |
EP3HTSMed is a one component, silver filled, electrically conductive epoxy system featuring high shear strength and a fast cure schedule at 250-300°F. The epoxy system fully meets USP Class VI requirements and has low volume resistivity of <0.001 ohm-cm. EP3HTSMed produces durable, high strength bonds which are resistant to severe thermal cycling and many chemicals. Tensile shear strengths in excess of 1,000 psi are readily obtained and its service operating temperature range is -60°F to 400°F.
For more information, request a technical data sheet on EP3HTSMed
|
| High Viscosity UV Curable Medical Adhesive |
UV10TKMed is USP Class VI approved and meets ISO10993-5 for cytotoxicity requirements. It is used in the assembly of medical devices and is capable of withstanding repeated sterilizations, including radiation, ethylene oxide, chemical sterilants and especially autoclaving. This higher viscosity, one part system has exceptional optical clarity, sterling physical properties and a very high glass transition temperature (Tg) that exceeds 140°C.
For more information, request a technical data sheet on UV10TKMed
|
|
A Must Read: Adhesives for the Medical Industry |
For an overview of our most popular medical grade epoxies, please browse this easy to read catalog organized by chemistry, key properties and curing schedules. From the prototype stage through the manufacturing process, each compound in this 20 page catalog is designed to meet specific application requirements.
For more information, request a catalog
|
|
|
|
Copyright  2014 by Master Bond Inc. All Rights Reserved. This content may not be reproduced in any way without the prior written permission of Master Bond Inc.
|
|
View this email online
November 2014
